Screws through the sheet
Exposed-fastener metal means the screws holding the sheets are visible on the roof. The example on this site is the Leesburg roof finished in September 2026. Sandy-tan architectural shingles, with a few orange tabs, stay on the main slope. Ribbed silver sheets sit on the shallow parts behind that slope. Each sheet is ribbed, with screws set in straight rows across the flats.
Other metal faces are on the metal roofing page. This page stays with sheets held by screws you can see.
Where screw-down sheets fit
They fit a shallow area behind a steeper shingle slope, where water from a heavy Florida rain crosses the pitch slowly. The Leesburg file says that about this house. It is not a rule for every low roof.
The main slope was re-covered in architectural shingles, and a ridge vent sits under the ridge pieces, its dark mesh showing along that line. The flatter parts behind the main slope got the ribbed sheets instead. Pick this face when screws in the field and a silver ribbed look are acceptable. Pass it by when the roof should read as shingles from the curb.
What the Leesburg photos record
One frame shows two metal heights. The upper sheet ends in a bent piece over the drop to the lower sheet, and the ribs on both run toward the street.
At the outside perimeter, trim wraps the sheet ends and turns down the face, screwed in place every few inches. A few blue layout marks still show on that new trim. Where the shingle slope meets the sheets, a long metal strip covers the joint. Two pipe vents rise through the shingles in front of that joint. A service mast with an overhead wire stands at the end of the ridge.
Large oaks hung with Spanish moss shade the yard. Single-story ranch houses sit across the street. Under the metal edge, a wood privacy fence runs past an older shed. The file names no brand and states no dollar figure. This site has no separate band for screw-down sheets.
Inland Lake County, not ocean spray
Leesburg sits inland in Lake County, under oaks. This screw-down example is not a beach metal-shingle roof. The file has no note about ocean spray or a corrosion limit. A house nearer the Atlantic should not treat these sheets as the match. Ask the maker for limits for that street before you do.
Answers from the Leesburg file
Which roofs get this screw-down sheet?
A shallow area behind a steeper shingle slope. On the Leesburg house, slow rain on that pitch is why the flatter rear got sheets instead of shingles. The note is about this house only.
Does the Leesburg file name a brand or a dollar figure?
No brand. No dollar figure. This site has no separate band for screw-down sheets.
What does a later repair run into?
A return visit meets the screw rows already in the flats and the screws in the perimeter trim. That is what the photos show. Keep the sheet description from the paperwork so a repair can match it. The photos show no daylight opening in the metal. The pipe vents in the file are on the shingle slope.
